Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
- 4. Cooling system
   4.2. Technical characteristics
   4.3. Thermostat
   4.4. Cooling fans
   4.5. Radiator and broad tank
   4.6. Water pump
   4.7. The sensor of temperature of cooling liquid
   4.8. Electric chain of the motor of the delivery fan
   4.9. Electric motor of the delivery fan
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
,



4.8. Electric chain of the motor of the delivery fan

GENERAL INFORMATION

Arrangement of the delivery fan

And – the delivery fan

In – the socket of the motor of the fan

The delivery fan is located under a ware box.



Check of the resistor of the motor of the delivery fan

Resistor contacts
Resistance
2 and 4
0,83 Ohm
2 and 3
1,12 Ohm
1 and 3
1,74 Ohm

Check of a gearshift of the delivery fan


Check

PERFORMANCE ORDER
1. If the delivery fan does not work, first of all, check connections of sockets in a fan chain. Check the fuse 2 on the panel of safety locks located under the dashboard. Check the relay of the delivery fan in the panel of fuses and the relay, located under a cowl.
2. Define an arrangement of the relay of the fan. Remove the relay and check, whether correctly it functions. If the relay is faulty, replace it.
3. Establish the gear shifting lever in parking situation and put the car on the hand brake. Establish the ignition key in the situation ON, without getting the engine.
4. Check, how the fan in all modes works.
5. If safety locks and the relay are in a normal state, and the fan does not work, test the fan.
Connect a tester to blue and red contacts. The tester should show at least 10 In – ignition is included, the switch of modes of the fan is in any situation except the situation OFF (Is switched off). If it not so, in a chain of the fan are malfunctions.
6. If tension moves on the fan, and it does not work, connect by means of a crossing point a black / white wire to grounding on a car body. If the fan still does not work, it is necessary to replace it. If the fan works, it means that in a chain of grounding of the fan there are malfunctions.
7. If the fan works, but not in all modes, check the resistor of the fan which is located on a fan casing (it is specified by an arrow).
8. Remove the resistor and examine it on existence of damages. Check the resistor by means of an ohmmeter. If necessary replace the resistor.
9. If the resistor functions normally, and the fan still works not in all modes, remove the heater control panel / the air conditioner. Disconnect wires from a back part of a gearshift of the fan and check resistance of the switch. If the switch is faulty, replace it.