Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
- 5. Heating and ventilation
   5.2. Control panel heater and air conditioner
   5.3. Heater radiator
   + 5.4. Central air and heating
   5.5. Electric chain of coupling of the compressor of the air conditioner
   5.6. Moisture separator of central air of air
   5.7. Compressor of the air conditioner
   5.8. Refrigerator of central air of air
   5.9. Evaporator of central air of air
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


5.2. Control panel heater and air conditioner

Removal and installation
PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the central finishing panel and remove radio.
3. Remove handles of management and unscrew control panel screws (are specified by shooters).
4. Disconnect wires (are specified by shooters) from the control panel – the Avalon model.
5. Disconnect two ropes (are specified by shooters) from a back part of the control panel – the Avalon model. Remove the control panel.
6. Installation is carried out upside-down removals.

Adjustment of operating ropes

PERFORMANCE ORDER
1. To adjust a rope operating a zaslonka of an air inlet, establish the lever in the situation FRESH, establish and fix a rope.
2. To adjust a rope the managing director of an air mix, establish the lever of an air mix in the situation COOL, establish and fix a rope (it is specified by an arrow).

Check of an electric chain

PERFORMANCE ORDER
1. Check central air switch, having connected a tester to contacts 2 and 5. When the switch is transferred to the situation ON, a chain between contacts 2–5 and 3–4 should be closed.
2. Test the switch of modes (see the table).
3. To replace any details of the control panel, remove handles (And), unscrew cover screws (In) and unscrew screws of switches (C).

Position of the handle of the switch
Contacts
Necessary condition
FACE
1–6
The chain is closed
B/L
1–5
The chain is closed
FOOT
1–4
The chain is closed
FOOT/DEF.
1–3
The chain is closed
DEF.
1–2, 7-8
The chain is closed