Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   + 9.1.2. Technical characteristics
   + 9.2. Steering
   - 9.3. Semi-axes
      9.3.2. Removal and installation of semi-axes
      9.3.3. Replacement of covers of a semi-axis
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


9.3.2. Removal and installation of semi-axes

Removal

Temporary fastening of a nave in need of a car perekatyvaniye at the removed semi-axes
1. Washer (external diameter of 50 mm)

2. Washer (external diameter of 18-25 mm)

3. Nut М14

4. Bolt М14

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Turn on the parking brake.
3. Remove a wheel cap (or naves), remove шплинт and a lock washer.
4. Release a nave nut.
5. Release wheel nuts, lift the car and remove a wheel.
6. Remove mud guards, unscrew a nave nut.
7. Disconnect a spherical support from the lever (see subsection 9.1.7.).
8. Weaken a semi-axis in a nave in sharp blow through a brass pro-rate. If necessary remove a brake disk (see subsection 10.6.) and a stripper displace a semi-axis.
9. On a part of cars remove a plastic casing, having unscrewed bolts.
10. Get a semi-axis from a nave.
11. At removal of the right semi-axis unscrew a lock bolt of an intermediate support and remove a lock ring.
12. Get a semi-axis from differential.
13. At removal of the left semi-axis get the internal hinge of a semi-axis from a check point.
14. If the car is necessary for rolling at the removed semi-axes, fix a nave a bolt with a nut.

Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down.
2. Sharply push an internal part of a semi-axis in order that the lock ring of differential came into a flute on the internal hinge.
3. A lock bolt of an intermediate support tighten with the set moment.
4. At first tighten nuts of wheels, then a nave nut with the set moment, establish a lock washer and зашплинтуйте.
5. Believe oil level in a check point.
6. At detection люфта or jammings of the bearing of an intermediate support replace a support (replacement is carried out in car-care center).