Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
10.2. Technical characteristics
10.3. ABS system
10.4. Blocks of disk brakes
10.5. Brake support
10.6. Brake disk
10.7. Blocks of drum-type brakes
10.8. Wheel cylinder of brakes
10.9. Main cylinder of brakes
10.10. Hoses and hydraulic actuator tubes
10.11. Air removal from a hydraulic actuator of brakes
10.12. Vacuum amplifier of brakes
10.13. Blocks of the parking brake of back disk brakes
10.14. Parking brake
10.15. Cables of the parking brake
10.16. Switch of a signal of braking
10.17. ABS: natural choice
10.18. Malfunctions of brake system
+ 11. Body
+ 12. Electric equipment
|
Check
| PERFORMANCE ORDER |
| 1. Release nuts of wheels, lift the car and establish on supports. Remove wheels and wrap nuts of wheels into place to fix a disk concerning a nave (to provide the annex of effort to a disk it is possible to dress washers). Release the parking brake (at works on a back brake). |
| 2. Remove a support (see subsection 10.5.), take aside and fix. Unscrew bolts and remove a support arm. |
|
3. Check a disk condition from both parties. At detection of traces of deep development (depth more than 1,0 mm), remove a disk and прошлифуйте. If when braking pulsations were noted, the increased palpation of a disk can be the reason. In drawing – a disk with traces from the slips worn out to rivets. A disk with such defects replace. |
|
4. Check palpation, having established the strelochny indicator in 13 mm from disk edge. If palpation on the indicator exceeds norm, remove a disk and прошлифуйте in car-care center. |
Prevention
|
|
The disk is recommended to be removed and ground periodically irrespective of indicator indications. At least it can be made by hand a small skin to reduce a roughness. |
|
|
5. After polishing the thickness of a disk should not be less maximum permissible which is cast on a disk. The minimum thickness is specified on disk inside, near a fastening place to a nave. |
|
6. Measure thickness of a disk in several places. |
|
Removal
| PERFORMANCE ORDER |
| 1. Unscrew wheel bolts which temporarily fixed a disk, and remove a disk. |
|
|
| 2. If the disk of a back brake does not give in to removal, unscrew a cap, enter into an opening a screw-driver (the opening should be at the very bottom) and rotating a regulator, take away blocks of the parking brake from a disk drum from the inside. |
|
3. Rotating a regulator, take away blocks of the parking brake from a disk drum (front view).
|
|
Installation
| PERFORMANCE ORDER |
| 1. Establish a back disk on hairpins. |
| 2. Establish an arm of a support and tighten all fastenings with the set moment. |
| 3. Establish a support and tighten fastening bolts. If the hose of a brake was not disconnected, to pump over brakes it is not necessary. |
| 4. Establish a wheel, nuts finally tighten after car lowering. After assembly press several times a brake pedal. Check work of brakes. |
|
|
|