Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS system
   10.4. Blocks of disk brakes
   10.5. Brake support
   10.6. Brake disk
   10.7. Blocks of drum-type brakes
   10.8. Wheel cylinder of brakes
   10.9. Main cylinder of brakes
   10.10. Hoses and hydraulic actuator tubes
   10.11. Air removal from a hydraulic actuator of brakes
   10.12. Vacuum amplifier of brakes
   10.13. Blocks of the parking brake of back disk brakes
   10.14. Parking brake
   10.15. Cables of the parking brake
   10.16. Switch of a signal of braking
   10.17. ABS: natural choice
   10.18. Malfunctions of brake system
+ 11. Body
+ 12. Electric equipment


10.10. Hoses and hydraulic actuator tubes
GENERAL INFORMATION

The condition of hoses and tubes is recommended to check each 6 months. At detection of cracks, podtekaniye, swellings and other damages a hose replace.

HOSES OF LOBBIES TOMOZOV

PERFORMANCE ORDER
1. Lift the car and remove a wheel.
2. Turn out the tube union from a hose.
3. Get a bracket of fastening of the union of a hose in an arm and pass a hose through an opening in an arm.
4. Unscrew a bolt of the union and disconnect a hose from a support.
5. Remove a bracket from an arm of a rack and get a hose through an arm.
6. Pass a new hose through a rack arm, establish new copper laying, combine a ledge on a hose with an opening in a support and tighten an union bolt with the set moment.
7. Pass a hose in an arm, screw an union nut by hand.
8. Insert a bracket (if it is provided insert also cutting washer) and tighten an union nut with the set moment.
9. Remove air from support cylinders.
10. Establish a wheel and lower the car.

HOSES BACK TOMOZOV

PERFORMANCE ORDER
1. Lift the car and remove a wheel.
2. Turn out the tube union from a hose.
3. Get a bracket of fastening of the union of a hose in an arm and pass a hose through an opening in an arm.
4. Remove air from the cylinder (support).

METAL TUBES

At replacement of tubes track, that on all route they were fixed by collars. The form of the bent new tubes should correspond to a form of the replaced. Installation of only steel tubes, in accuracy corresponding to make of the car is allowed. Use of copper tubes is not allowed. Track, that the tube lay at sufficient distance from moving or warm details.

After replacement of a tube remove air from a hydraulic actuator (see subsection 10.11.).