Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
- 1.2. Information before car driving
   + 1.2.2. Brake system
   1.2.3. Precautionary measures when laying luggage
   + 1.2.4. Toyota car identification
   1.2.5. Suspension bracket and chassis
   - 1.2.6. Start and driving in a critical situation
      1.2.6.2. If the engine decays during movement
      1.2.6.3. If the car overheats
      1.2.6.4. If the tire is lowered
      1.2.6.5. If the car needs towage
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


1.2.6. Start and driving in a critical situation

1.2.6.1. Start by means of the additional storage battery

GENERAL INFORMATION


If the additional storage battery is established on other car, be convinced that cars do not adjoin. Switch off all unnecessary light devices and auxiliary the equipment.

If it is necessary, remove all ventilating jams from the additional and discharged storage batteries. Put a fabric over open ventilating openings on storage batteries. (It helps to lower danger of explosion, traumas and burns).

If the car engine with the additional storage battery does not work, start it and let's to it work within several minutes. During start by means of the additional storage battery the engine should work approximately at speed of 2000 rpm at slightly pressed pedal of an accelerator.

Execute connection of cables as a, b, c, d:

a. Connect a clip of a positive (red) connecting cable to positive (+) to the plug on the discharged storage battery.

b. Connect a clip on other end of a positive (red) connecting cable to positive (+) to the plug on the additional storage battery.

c. Connect a clip of a negative (black) connecting cable to the negative (-) the plug on the additional storage battery.

d. Connect a clip on other end of a negative (black) cable to a firm, motionless, unpainted, metal point of the car with the discharged storage battery.

Points recommended for connection are shown in the following drawings.

Connection point for the engine 5S-FE


Connection point for the engine 1MZ-FE


Do not connect a cable to or near any part which moves at a provorachivaniye of a cranked shaft of the engine. At performance of connections in order to avoid a serious trauma do not bend over the storage battery and do not allow, that connecting cables or clips touched something, except the necessary plugs of storage batteries and grounding.

Start the engine in the usual way. After start it should work within several minutes for speed about 2000 rpm at slightly pressed pedal of an accelerator.

Carefully disconnect cables precisely in return sequence: negative cable, and then positive cable.

Carefully liquidate the fabrics covering storage batteries – they can contain sulfuric acid.

If ventilating jams were removed, establish them everything on places.

If the reason of a discharge of the storage battery is not revealed (for example, there were included light devices), it is necessary to check it.