Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
- 1.3. Independent maintenance
   1.3.1.2. Choice of engine oil
   1.3.1.3. Check of level of cooling liquid of the engine
   1.3.1.4. A choice such as a coolant
   1.3.1.5. Check and replacement of the filter of the air conditioner
   - 1.3.2. Wheels and tires
      1.3.2.2. Check and replacement of tires
      1.3.2.3. Shift of tires
      1.3.2.4. Installation of tires for movement on snow and antisliding chains
      1.3.2.5. Replacement of wheels
   + 1.3.3. Electric components
   1.3.4. A water additive in a washer tank
   + 1.3.5. Replacement of lighting lamps
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


1.3.2.5. Replacement of wheels

GENERAL INFORMATION

When it is necessary to replace wheels

If the wheel has damage, for example, a bend, cracks or strong corrosion, – it should be replaced. Otherwise the tire can slide off a wheel or it will lead to management loss.

Choice of wheels


Wheels should be replaced by at what same permissible load, diameter, width of a rim and a departure. The wheel of other size or type can negatively influence driving, wheel and bearing service life, cooling of brakes, speedometer / odometer calibration, ability of a stop, aiming of headlights, bumper height, a road clearance of the car and an interval from the tire or an antisliding chain to a body and the chassis.

Replacement by the used wheels is not recommended. Never use a tire tube in a wheel with leak which was designed for the tubeless tire.

Aluminum wheels

After passing by the car of the first 1600 km check, that nuts of wheels were normally tightened.

If shift, repair or replacement of tires was carried out, check, that nuts of wheels were still tightened after passing of 1600 km.

When using chains be careful not to damage aluminum wheels.

Use only nuts of wheels and a wrench Toyotas intended for aluminum wheels.

When balancing wheels use only counterbalances of Toyota firm or equivalent to them and a plastic or rubber hammer.

As well as when using any wheels, periodically check aluminum wheels on damage. If it is, immediately replace a wheel.