Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   + 9.1.2. Technical characteristics
   - 9.2. Steering
      9.2.2. Steering wheel
      9.2.3. Tips of steering drafts
      9.2.4. Covers of the steering mechanism
      9.2.5. Steering mechanism
      9.2.6. Pump of the hydraulic booster
      9.2.7. Air removal from a power steering contour
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


9.2.2. Steering wheel
GENERAL INFORMATION
Prevention

Considered cars are equipped with a safety cushion (SRS system). At works near details of a safety cushion disconnect the battery in order to avoid operation of system and traumas.

Removal

PERFORMANCE ORDER
1. Transfer the ignition key to the situation OFF and disconnect the battery from weight. Remove the positive plug of the battery and wait for not less than 2 minutes.
2. Turn a wheel and establish wheels in the provision of driving on a straight line, hook a screw-driver and remove caps of screws on both parties of a wheel. Release two screws of fastening of the module of a safety cushion (1 – the screw with a krestovy shliyets, 2 – the screw case). Screws release until then while dredging on a screw head will not come into an opening of the case of the screw.
3. Remove the safety module.
4. Press a socket clamp
5. Disconnect the socket.
6. Disconnect sockets of a sound signal and system cruise control.
7. Unscrew a nut of fastening of a wheel and designate the provision of a wheel concerning a shaft (on parts of cars of a label of orientation of a wheel are put with the manufacturer).
8. Vypressuyte steering wheel. Remove a wheel a stripper. It is forbidden to remove a wheel in blows on a nave.

Installation

PERFORMANCE ORDER
1. Be convinced that wheels are established in the provision of driving on a straight line. Turn a spiral wire counter-clockwise to feeling of hard rotation. Turn a wire clockwise on three turns and combine two indexes of red color. At the correct installation the spiral should turn in both parties on three turns.
2. Combine wheel and shaft labels, establish a wheel and tighten a nut with the set moment.
3. Attach sockets cruise control and a sound signal.
4. Attach the socket of the module of safety.
5. Establish the module of safety and tighten screws with the set moment.
6. Attach to the wire battery.