Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   + 9.1.2. Technical characteristics
   - 9.2. Steering
      9.2.2. Steering wheel
      9.2.3. Tips of steering drafts
      9.2.4. Covers of the steering mechanism
      9.2.5. Steering mechanism
      9.2.6. Pump of the hydraulic booster
      9.2.7. Air removal from a power steering contour
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment



9.2.5. Steering mechanism

GENERAL INFORMATION

Steering mechanism and details of its installation

1. Protective panel of the left wing
2, 3. Шплинт
4. Protective panel of the right wing
5. Stabilizer bar

Removal
Prevention

At dismantle of the steering mechanism take measures excluding turn of a steering shaft, otherwise it is possible to damage a spiral wire of a safety cushion. For this purpose the ignition key transfer to the situation "Parking", or wind a wheel with a seat belt and insert a wheel buckle into the lock.


PERFORMANCE ORDER
1. Establish wheels in the provision of driving on a straight line. Lift a forward part of the car and establish on supports. Turn on the parking brake and remove both lobbies of a wheel. Remove protective panels of a case of the engine (if are provided).
2. Turn on the union of pressure head and return tubes of the hydraulic booster. Muffle tubes. Remove from the steering mechanism an arm.
3. Designate mutual orientation of the bottom kardanny hinge of a steering shaft and a shaft of the steering mechanism. Unscrew a coupling bolt and a nut of a collar (arrow).
4. Disconnect steering drafts.
5. Unscrew bolts of fastening of collars of plugs of the stabilizer (for access to bolts of the steering mechanism).
6. Unscrew nuts of fastening of the steering mechanism, raise a bar of the stabilizer and beat out bolts of fastening of the steering mechanism.
7. Separate an intermediate shaft from a shaft of the steering mechanism and get the steering mechanism on the right side of the car.
8. Check a condition of rubber plugs through which the steering mechanism fastens. In need of the plug replace.

Installation

PERFORMANCE ORDER
1. Establish the steering mechanism and attach the kardanny hinge, having combined the labels put at dismantling.
2. Turn and tighten bolts and nuts of fastening of the steering mechanism with the set moment.
3. Attach steering drafts.
4. Tighten a coupling bolt of a collar of the kardanny hinge.
5. Attach tubes of the hydraulic booster and tighten the union.
6. Establish a stabilizer bar.
7. Lower the car and remove air from a power steering contour.