Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmission
   + 8.1.2. Care of MKPP
   - 8.2. Automatic transmission
      8.2.2. Technical characteristics
      8.2.3. Care of AKPP
      8.2.4. General diagnostics
      8.2.5. Rope of the lever of gear shifting
      8.2.6. Butterfly valve rope
      8.2.7. Switch of blocking of ignition
      8.2.8. System of blocking of the lever of gear shifting
      8.2.9. Replacement of epiploons
      8.2.10. Removal and AKPP installation
      8.2.11. Electronic control system
      8.2.12. "Machine gun"
   + 8.3. Coupling
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

8.2.5. Rope of the lever of gear shifting

Adjustment

PERFORMANCE ORDER

1. Lift and fix a forward part of the car.

2. Remove the protective guards closing space a boundary by a forward part of the car and the bottom cross-piece.

3. Weaken a nut of the switching lever on a transmission (it is specified by an arrow).

4. Establish switching lever in parking situation (against the stop up), and then on two clicks down in neutral situation (4-cylinder models, transmission А140Е).

5. Establish switching lever in parking situation (against the stop down), and then on two clicks up (6-cylinder models, transmission А541Е).

6. Establish the gear shifting lever in salon in neutral situation.

7. Tighten a lock nut.

8. Check, how the lever of switching and a transmission functions.

Replacement

PERFORMANCE ORDER

1. Disconnect a rope from the switching lever on a transmission (the nut is specified by an arrow).

2. Remove a big clamp of a rope (it is specified by an arrow), located over the lever. Disconnect a rope from an arm.

3. Unscrew bolts of a clamp of a rope (are specified by shooters), located on a dividing partition.

4. Remove the central panel.

5. Remove a big clamp of a rope.

6. Remove a wire clamp, beat out a lock pin (it is specified by an arrow) and disconnect a rope from the gear shifting lever.

7. Remove a rope.

8. Installation is carried out upside-down removals.