Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   6.2. Technical characteristics
   6.3. Pressure dumping in fuel system
   6.4. Fuel pump and pressure of fuel
   6.5. Fuel tubes and connections of tubes
   6.6. Removal and installation of the fuel pump
   6.7. Regulator of pressure of fuel
   6.8. Sensor of the index of level of fuel
   6.9. Fuel tank
   6.10. Cleaning and repair of a fuel tank
   6.11. Casing of the air filter
   6.12. Accelerator rope
   6.13. Electronic system of injection of fuel
   6.14. Throttle
   6.15. Fuel highway and injectors
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

6.14. Throttle

GENERAL INFORMATION

Four-cylinder engines

1. Vacuum hoses
2. Laying
3. A hose of the system catching pairs of fuel
4. Butterfly valve casing
5. Wire of the sensor of provision of a butterfly valve
6. Wire
7. A pipe connecting a throttle to the air filter

8. Roundabout a hose of cooling liquid
9. Air hose
10. Roundabout a hose of cooling liquid
11. Butterfly valve rope
12. Accelerator rope
13. A hose of the system catching pairs of fuel
14. Temperature sensor of system of a retsirkulyatsiya of final gases.

Functioning of vacuum ports of a throttle – 4-cylinder models

Port name	Idling	Other modes
R	there is no vacuum	vacuum
Е	there is no vacuum	vacuum
R	there is no vacuum	there is no vacuum

Check

PERFORMANCE ORDER

1. Examine the lever mechanism, it should function smoothly and not jam.
2. Get the engine, in turn disconnect vacuum hoses from a throttle. Whether check there is a vacuum idling and at higher turns. Compare results of check to table data Functioning of vacuum ports of a throttle – 4-cylinder models.

3. Remove an airintaking pipe and check a throttle on deposit and dirt existence. If necessary wash out a throttle special solution for cleaning of carburetors.

Replacement

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the airintaking pipe connecting the case of a throttle to the air filter.
3. Disconnect an accelerator rope from the butterfly valve lever.
4. Disconnect from a throttle casing hoses and wires.
5. Disconnect a wire from the sensor of provision of a butterfly valve.
	6. Unscrew assembly bolts of a throttle.
7. Disconnect a throttle from an inlet collector.
8. Installation is carried out upside-down removals.