Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Transmission
   + 8.1.2. Care of MKPP
   + 8.2. Automatic transmission
   - 8.3. Coupling
      8.3.2. Coupling – the description and check
      8.3.3. Coupling details
      8.3.4. Vyzhimna bearing and fork
      8.3.5. Main cylinder of coupling
      8.3.6. Working cylinder of coupling and accumulator
      8.3.7. Coupling hydraulic actuator
      8.3.8. The blocking switch of coupling
      8.3.9. Probuksovochka
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

8.3.2. Coupling – the description and check

GENERAL INFORMATION

Coupling dry, one-disk diafragmenny type with a hydraulic drive.

Consistently main and working cylinders through which effort transfer from a pedal on a fork and on vyzhimny the bearing of switching off of coupling is provided are switched on in a contour of a hydraulic actuator. On cars with the V6 engine the hydroaccumulator is in addition provided.

It is recommended to execute the following preliminary checks which allow to define a coupling condition.

PERFORMANCE ORDER

1. Check liquid level, if necessary restore (if the tank is empty, add liquid and pump over a hydraulic actuator).

2. For check of coupling press a pedal idling the engine and some seconds later include a reverse gear. The gnash will indicate the strengthened wear of press or frictional disks.

3. Check completeness of switching off of coupling. For this purpose on the working engine press a coupling pedal so that the pedal did not reach a floor on 13 mm. Be several times switched from the 1st transfer to the back. The complicated switching indicates wear of details. Check a course of a rod of the working cylinder at completely pressed pedal. If the course is small, check liquid level.

4. Be convinced that the fork of coupling has no люфта on a spherical support.

5. Check wear of the plug of a pedal in the top part.