Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and suspension bracket spring
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. Steering
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.16. Corners of installation of wheels

GENERAL INFORMATION

Disorder of wheels, longitudinal and cross-section tilt angles of an axis of turn are provided with a design of a suspension bracket and to adjustment are not subject.

It is independently allowed to regulate a convergence of lobbies and back wheels and a limiting angle of rotation of wheels though these procedures are recommended to be executed with high precision in car-care center.

The convergence of wheels is checked on a difference of distances between extreme points on disks of the wheels measured at level of the center of wheels (measurements are carried out at dry mass of the car when pressure in tires corresponds to norm, and the car is parked on an equal horizontal platform). At first the distance is measured in a back part of wheels, then the car is rolled on 180 ° and the distance between the same points is measured in their forward part. For increase of accuracy it is recommended to measure a convergence on 3 points located on a circles of a disk of a wheel through 120 ° and to define an average convergence.