Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and suspension bracket spring
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. Steering
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.14. Nave and bearing of a back wheel

GENERAL INFORMATION

Details of a nave of a back wheel with bearing knot

1. Cylinder
2. Brake disk
3. A nave of a back wheel with the bearing

4. Sealing ring of a nave
5. Brake drum

Removal

Prevention

Nave of a back wheel with the bearing to repair are not subject and change as uniform knot.

PERFORMANCE ORDER

1. Lift a back part of the car and establish on supports. Remove a back wheel.
2. Remove a drum or a brake disk (see subsection 10.6.).
	3. Unscrew 4 bolts of fastening of the case of a nave to a suspension bracket arm through openings in a nave flange. For access to bolts the flange is necessary for turning.
4. Remove a nave assembled with the bearing.
5. Remove a sealing ring of a nave.

Installation

PERFORMANCE ORDER

1. Establish a nave and combine openings in the nave case with openings under bolts in a brake board. Wrap bolts. At installation of bolts in carving openings it is convenient to use a magnet. Tighten bolts with the set moment.

2. Establish a drum (or a disk) brakes, a support and a wheel. Establish a wheel and lower the car.