Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
- 9.1.2. Technical characteristics
9.1.3. Stabilizer of cross-section stability of a forward suspension bracket
9.1.4. Rack of a forward suspension bracket
9.1.5. Rack and suspension bracket spring
9.1.6. Suspension bracket lever
9.1.7. Spherical support
9.1.8. Rotary fist and nave
9.1.9. Nave and bearing of a forward wheel
9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
9.1.11. Rack of a back suspension bracket
9.1.12. Longitudinal bar
9.1.13. Levers of a back suspension bracket
9.1.14. Nave and bearing of a back wheel
9.1.15. Arm of a back suspension bracket
9.1.16. Corners of installation of wheels
+ 9.2. Steering
+ 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Prevention
Shock-absorbers of racks change only in pair.
Removal
| PERFORMANCE ORDER |
| 1. Lift a forward part of the car and establish on supports. Remove forward wheels. Substitute a jack under the suspension bracket lever. |
|
2. Disconnect from a rack an arm of a tube of a hydraulic actuator. |
| 3. On the cars equipped with ABS system, unscrew a bolt of a collar of conducting and disconnect conducting from the sensor of speed. |
|
4. Unscrew the specified nuts of fastening of a rack to a rotary fist and a hammer and to small beards beat out bolts. |
| 5. Disconnect a rack from a rotary fist. Take measures to damaging a cover of the internal CV JOINT, and also do not allow fist falling as the brake hose will be thus damaged. |
|
6. Holding the top part of a rack, unscrew three nuts of fastening to a cap of a suspension bracket (arrow) and get a rack from a wheel niche. |
|
Check
| PERFORMANCE ORDER |
| 1. Check existence on the case of a rack of cracks and other visible damages. |
| 2. Check a spring condition, existence on rounds of cracks of a covering (leads to a premature exit of a spring out of operation owing to aging), hardening and damages on isolating laying of a spring. |
| 3. At detection of damages disassemble a rack and replace the damaged details. |
|
Installation
| PERFORMANCE ORDER |
| 1. Working together, establish a rack so that hairpins entered into openings of a cap and screw nuts. |
| 2. Get a rack flange in a rotary fist, insert bolts and screw nuts. Tighten nuts with the set moment. |
| 3. Fix on a rack a hose arm. Attach the socket to the sensor of speed. |
| 4. Establish a wheel and lower the car. |
| 5. Tighten three nuts of the top fastening of a rack. |
|
|
|