Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and suspension bracket spring
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. Steering
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


9.1.6. Suspension bracket lever

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and remove a wheel from that party from which the suspension bracket lever will be dismantled.
2. Disconnect draft of the stabilizer from the lever (see subsection 9.1.3.).
3. Unscrew specified a bolt and nuts of fastening of a spherical support to the lever.
4. Operating with mount, take away the suspension bracket lever from a rotary fist.
5. Unscrew two bolts of fastening of a forward part of the lever of a suspension bracket to a frame of the engine (arrow).
6. Unscrew a bolt and a nut of fastening of a back part of the lever of a suspension bracket to a frame of the engine (arrow).
7. Remove the lever.

Check

PERFORMANCE ORDER
1. Check existence on the lever of deformations. At detection of curvature replace the lever. Rikhtovka of the lever is forbidden.
2. Check a condition of plugs of the lever. At detection on plugs of cracks, gaps and traces of strong wear the lever assembled replace.

Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down. All carving connections tighten with the set moments.
2. Establish a wheel and lower the car.
3. Check and if necessary adjust corners of installation of wheels.