Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a cranked shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / leader disk
      3.1.15. Back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3.1.12. Oil pallet

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Lift and fix a forward part of the car.
3. Remove protective guards of the engine.
4. Merge engine oil and remove the oil filter.
5. Braid the nuts, fixing forward section of an exhaust pipe to a final collector, unscrew the bolts, fixing the catalytic converter to final system, remove an arm and remove forward section of an exhaust pipe. Remove fastening of a final collector.

6. Unscrew bolts (shooters) and remove an arm of the block of cylinders and a transmission.

7. Unscrew bolts and remove the oil pallet from the block of cylinders.

Installation

PERFORMANCE ORDER
1. Carefully clean and wipe acetone being joined surfaces of the pallet and the block of cylinders, clean carvings in block openings. Check, whether the pallet flange is bent, if necessary correct it.
2. Examine a maslozaborny branch pipe on existence of a contamination of cracks or other damages.
3. Put hermetic on a pallet flange (And – in a flute, In – from opening inside).
4. Establish the pallet and insert bolts. Tighten bolts till the demanded moment of an inhaling.
5. Establish the remained details, get the engine and check it on existence of leaks.