Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a cranked shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / leader disk
      3.1.15. Back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3.1.16. Engine fastenings
GENERAL INFORMATION

Typical fastenings of the 4-cylinder engine

1. The draft regulating shift of the engine
2. Back support of the engine
3. Mechanical transmission
4. Automatic transmission
 5. Collector fastening
6. Forward support of the engine
7. Engine arm

Check

PERFORMANCE ORDER
1. Lift and fix a forward part of the car. Establish a jack under the oil pallet.
2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary replace them.
3. Check, that bolts of support were strong tightened.
4. Check, whether support are worn-out.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator. Lift and fix a forward part of the car.
2. To remove the right support, braid a nut and get a through bolt.
3. Braid nuts fixing a support to an arm and remove a support.
4. To remove a back support, get three rubber stoppers and braid support nuts.
5. To remove a forward support, braid a nut, fixing it to an engine arm, and unscrew three bolts fixing a support to a body.
6. Installation is made upside-down.