Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a cranked shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / leader disk
      3.1.15. Back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.1.14. Flywheel / leader disk

Removal

PERFORMANCE ORDER

1. Lift and fix the car on support. Remove a transmission.
2. Remove press a disk and a disk of the coupling of coupling (for engines with a mechanical transmission).
	3. Make adjusting labels (arrows) on a flywheel and on a cranked shaft.
4. Unscrew bolts of the flywheel / leader of a disk, if necessary block a flywheel a screw-driver.
	5. Remove the flywheel / leader a disk. In cars with an automatic transmission from both parties of a leading disk intermediate rings are established. At carrying out assembly, the opening in an intermediate ring should coincide with a pin (it is specified by an arrow).

Installation

PERFORMANCE ORDER

1. Clean a flywheel and examine its surface on existence of cracks, scratches and the burned sites. It is possible to remove small damages, having processed a surface an emery paper. Check, whether there is no absent teeth and whether the flywheel is deformed.

2. If necessary replace a back epiploon of a cranked shaft.

3. Establish a flywheel on a cranked shaft, using labels made during removal procedure. Put pressurizing structure on carvings of bolts and insert bolts. Tighten bolts till the demanded moment of an inhaling.