Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a cranked shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / leader disk
      3.1.15. Back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.1.5. Inlet collector

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Weaken a clip, a fixing hose of the air filter to a throttle, remove the top part of the air filter, the resonator and a hose.
3. Disconnect hoses of system of cooling from a throttle and закупорьте them to avoid leakage of cooling liquid.
4. Disconnect all ropes and the wires fixed on an inlet collector.
	4. Not to mix hoses in an installation time make on them labels.
	5. Liberate wires from clamps.
	6. Disconnect wires of grounding (shooters).
	7. Unscrew bolts of an arm of a collector (arrow).
	8. Disconnect wires from the coil, unscrew bolts (shooters) and remove a collector arm.
	9. Unscrew assembly bolts, braid nuts and disconnect a collector from the engine.

Installation

PERFORMANCE ORDER

	1. Carefully clean being joined surfaces of a collector and a head of cylinders. If you found out that laying of a collector proceeded, check, whether the collector is deformed, if necessary address to the expert.
2. Establish new laying, establish a collector and insert bolts.
3. Tighten bolts till the demanded moment of an inhaling.
4. Establish the remained details, check, whether draft of a drive of a throttle freely functions, get the engine and check it on existence of leaks.