Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
      3.2.2. Compression check
      3.2.3. Top dead point (VMT) of the N1 piston
      3.2.4. Covers of heads of cylinders
      3.2.5. Inlet collector
      3.2.6. Final collectors
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. Oil pallet
      3.2.13. Oil pump
      3.2.14. Flywheel / leader disk
      3.2.15. Back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.2.11. Heads of cylinders

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Merge cooling liquid.
3. Remove the top and bottom sections of an inlet collector.
4. Remove final collectors.
5. Remove a gas-distributing belt, asterisks of camshafts and the top intermediate pulley.
6. Unscrew bolts of a back cover of a gas-distributing belt.
7. Lift the receiver cooling liquid.
8. Remove camshafts.
9. Unscrew bolts and disconnect plaits of wires from back parts of heads.
	10. Unscrew the drowned bolts of heads.
	11. Weaken other bolts of heads in sequence, the return sequence of their tightening shown in drawing. Weaken bolts on a turn quarter at one time.
12. Remove heads.

Installation

PERFORMANCE ORDER

1. Carefully clean and wipe acetone being joined surfaces of heads and the block of cylinders. If surfaces are scratched or damaged otherwise, they are necessary for processing in a specialized workshop.
2. By means of a suitable tap clean carvings in the block of cylinders. By means of a suitable die clean bolts of heads of cylinders.
	3. Establish new laying and establish one of heads.
4. Grease bolts with pure engine oil.
5. Insert bolts and tighten them till the demanded moment of an inhaling of the first step in the specified sequence. Do not tighten the drowned bolt.
6. Hold on bolts for 90 ° and tighten the drowned bolt.
7. Similarly establish other head.
8. Establish the remained details.