Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Compression check
   - 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
      3.2.2. Compression check
      3.2.3. Top dead point (VMT) of the N1 piston
      3.2.4. Covers of heads of cylinders
      3.2.5. Inlet collector
      3.2.6. Final collectors
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Forward epiploon of a cranked shaft
      3.2.9. Epiploons of camshafts
      3.2.10. Camshafts and lifts of valves
      3.2.11. Heads of cylinders
      3.2.12. Oil pallet
      3.2.13. Oil pump
      3.2.14. Flywheel / leader disk
      3.2.15. Back epiploon of a cranked shaft
      3.2.16. Engine fastenings
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3.2.12. Oil pallet

Removal

PERFORMANCE ORDER
1. Remove a cowl.
2. Disconnect a wire of the minus plug of the accumulator.
3. Lift and fix a forward part of the car.
4. Remove protective guards of the engine.
5. Merge engine oil and remove the oil filter.
6. Disconnect forward section of an exhaust pipe from the catalytic converter, an arm and final collectors.
7. Unscrew two bolts and uncover a flywheel casing.
8. Unscrew the bolts, fixing aluminum section of the pallet to a transmission.
9. Unscrew bolts and remove steel section of the pallet.
10. Unscrew bolts of a maslozaborny branch pipe (arrow) and remove it.
11. Unscrew bolts of aluminum section of the pallet.
12. If necessary remove a dividing partition of the pallet.

Installation

PERFORMANCE ORDER
1. Carefully clean and wipe acetone being joined surfaces of both sections of the pallet and the block of cylinders, clean carvings in block openings. Check, whether the pallet flange is bent, if necessary correct it.
2. Establish a dividing partition.
3. Put hermetic on a being joined surface of aluminum section.
4. Establish aluminum section and tighten bolts till the demanded moment of an inhaling.
5. Examine a maslozaborny branch pipe on existence of a contamination of cracks or other damages. Establish a branch pipe (if you removed it) and tighten bolts.
6. Put hermetic on a flange of steel section of the pallet. Establish section, insert bolts and tighten them till the demanded moment of an inhaling.
7. Establish the remained details, get the engine and check it on existence of leaks.