Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   - 3.4. Engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. Storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. Coil (and) ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. Block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Tension and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay
      3.4.15. Main malfunctions of electric equipment
      3.4.16. That it is necessary to know to the owner of the car with the injector engine
      3.4.17. Turbo doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.4.13. Starter electric motor

GENERAL INFORMATION

Starter conclusions

1. Traction relay
2. Starter

3. Vice
4. Switch

If there are suspicions on malfunction of a chain of a starter, be convinced that the battery is charged, check purity reliability of fastening of wires, serviceability of the blocking switch of the situation Park/Neutral or coupling (on and/m from a manual transmission). Check also serviceability of the relay of a starter (is in the assembly block of the relay in a motor compartment).

If the electric motor of a starter does not rotate at all at key turn, check tension on the traction relay. If tension is, remove a starter and check.

At slow rotation of a starter check tension and a current at start-up which at not so low temperature, later no more than 10 with the ambassador of inclusion of a starter should be not lower respectively 8,0 In and 250–400 A.Esli a starting current do not correspond to the specified limit, a starter replace, previously having checked serviceability of wires, connections and the battery.

If tension on a starter is, but the starter does not rotate, remove a starter for check. For check of a starter collect the scheme, having connected wires the specified conclusions (see fig. Starter conclusions). If the obgonny coupling is put forward, but the starter does not rotate, the starter is faulty. If clicks are listened, and the coupling is not put forward, are faulty either the relay, or a starter.

Removal

Details of installation of a starter (the 4-cylinder engine)

1. Socket
2. Starter
3. Power cable

Details of installation of a starter (the 6-cylinder engine)

1. Socket
2. Starter
3. Power cable

PERFORMANCE ORDER

1. Remove the battery.

2. Remove an aktyuator cruise control.

3. Disconnect from a wire starter.

4. Unscrew starter bolts.

5. Remove an arm from the top part of a starter. For this purpose release 1–2 bolts of an arm, приопустите a starter and unscrew other bolts.

Installation

Installation is carried out upside-down.