Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   - 3.4. Engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. Storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. Coil (and) ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. Block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Tension and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay
      3.4.15. Main malfunctions of electric equipment
      3.4.16. That it is necessary to know to the owner of the car with the injector engine
      3.4.17. Turbo doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment



3.4.6. Coil (and) ignitions

GENERAL INFORMATION

On V6 engines transfer the ignition key to the situation Off, disconnect sockets from coils and check resistance of primary chains of coils.

Prevention

On 4-cylinder engines this procedure is not provided.


Check resistance of secondary chains of coils. For this purpose transfer the ignition key to the situation Off, designate and disconnect from coils high-voltage wires (the 4-cylinder engine).


On V6 engines it is necessary to remove the coil. If resistance differ from standard, the coil of ignition replace.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight.

4-CYLINDER ENGINES

PERFORMANCE ORDER
2. Remove a throttle branch pipe (see subsection 6.14.).
3. Designate and disconnect from the coil the socket and high-voltage wires.
4. Unscrew bolts (shooters) and remove the coil with an arm.
5. Unscrew bolts and remove the coil from an arm.
6. Installation is carried out upside-down.

6-CYLINDER ENGINES

PERFORMANCE ORDER
2. Designate and disconnect from the coil the socket and high-voltage wires.
3. Unscrew bolts and remove the coil from an arm.
4. Installation is carried out upside-down.