Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   - 3.4. Engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. Storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. Coil (and) ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. Block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Tension and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay
      3.4.15. Main malfunctions of electric equipment
      3.4.16. That it is necessary to know to the owner of the car with the injector engine
      3.4.17. Turbo doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3.4.3. Storage battery

Engine start-up in emergency situations

See subsection 1.2.6.

Check

PERFORMANCE ORDER
1. Disconnect from the cable battery both, having begun with a negative pole.
2. Check the color indicator. If the indicator of black color, charge the battery. Check tension which should be 11,5–12,0 In (previously, before battery shutdown, it is recommended it is necessary to include a driving beam of headlights on 10 with, to turn off the light and other consumers).
3. Periodically it is necessary to check the battery the special loading device. At room temperature tension on the battery should not fall below 9,6 Century.

Replacement

PERFORMANCE ORDER
1. Disconnect from the battery cables.
2. Unscrew nuts of fastening (shooters) and disconnect a fastening collar, remove the battery.
3. At replacement of the battery be convinced that parameters of the new battery (dimensions, capacity and a return current) just the same, as at the replaced.