Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   + 3.1.2. Compression check
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   - 3.4. Engine electric equipment
      3.4.2. Technical characteristics
      3.4.3. Storage battery
      3.4.4. Power cables
      3.4.5. Ignition system
      3.4.6. Coil (and) ignitions
      3.4.7. Check of the moment of ignition
      3.4.8. Block of electronic ignition
      3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Tension and brush regulator
      3.4.12. System of start-up of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay
      3.4.15. Main malfunctions of electric equipment
      3.4.16. That it is necessary to know to the owner of the car with the injector engine
      3.4.17. Turbo doctor
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.4.7. Check of the moment of ignition

GENERAL INFORMATION

Prevention

Procedure of installation of the moment of ignition is applicable almost to all cars considered in this Management. If the order of installation of the ignition, specified in the podkapotny plate of the car, differs from described below, be guided by the plate instruction. The ignition moment on all considered cars is not regulated, therefore, at violation of installation of ignition it is necessary to check serviceability of units of system of ignition.

PERFORMANCE ORDER

1. Connect a tachometer, being guided by the instruction of the manufacturer of the device.
	2. Find the diagnostic socket and close накоротко conclusions Е1 and TE1.
3. At the switched-off ignition connect a stroboscope, being guided by the instruction of the manufacturer of the device.
	4. Find labels of the moment of ignition (shooter) on a forward cover and on a crankshaft pulley.
5. Warm up the engine, be convinced that turns of idling of the engine of 700 rpm on and/m from a manual transmission and 750 rpm on and/m with automatic transmission. Direct stroboscope light on a scale. The label on a pulley of the crankshaft should be opposite to the corresponding division of a scale.