Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
- 7. Exhaust system
   - 7.2. Systems of decrease in toxicity of exhaust gases
      7.2.2. Technical characteristics
      7.2.3. OBD II system
      7.2.4. OBD computer of II system (Powertrain Control Module)
      7.2.5. Sensor of turn of a butterfly valve
      7.2.6. The sensor of absolute pressure in a soaking-up collector
      7.2.7. Sensor of a mass consumption of air
      7.2.8. The sensor of temperature of soaked-up air (IAT sensor)
      7.2.9. The sensor of temperature of cooling liquid (ECT sensor)
      7.2.10. Sensor of rotation of the crankshaft
      7.2.11. Sensor of rotation of a cam-shaft
      7.2.12. Contact sensor of pressure of the hydraulic booster
      7.2.13. The sensor of the content of oxygen in the fulfilled gases
      7.2.14. Detonation sensor
      7.2.15. Sensor of speed of the car
      7.2.16. Perepuskna air valve of idling (IAC valve)
      7.2.17. System of a choice of the channel absorptions (ACIS system)
      7.2.18. System of ventilation of a case
      7.2.19. Retsirkulyatsiya system
      7.2.20. Catching system паров gasoline
      7.2.21. Converter
      7.2.22. Rub in one – or how to save the catalyst
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


7.2.15. Sensor of speed of the car

GENERAL INFORMATION

The sensor is intended for management of transmission and fuel consumption control. The signal from the sensor represents sequence of impulses. The sensor fastens on a transmission case.

Check

PERFORMANCE ORDER
1. Disconnect the socket (on fig. at the left – the 4-cylinder engine, on the right – 6-cylinder) and check existence of tension 12 In on it is red / a dark blue wire. If tension is not present, check a chain between the sensor and a fusible crossing point.
2. Having lifted the car, check existence of pulsing tension 11 In from the sensor at wheel rotation (the second wheel hold). For this purpose attach the socket and connect positive щуп the voltmeter from the back party of the socket to a conclusion with a dark blue wire, and negative – to a conclusion with a pink wire. In the absence of tension the sensor replace.

Replacement

PERFORMANCE ORDER
Disconnect the socket, unscrew the screw and get the sensor.