Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
- 7. Exhaust system
   - 7.2. Systems of decrease in toxicity of exhaust gases
      7.2.2. Technical characteristics
      7.2.3. OBD II system
      7.2.4. OBD computer of II system (Powertrain Control Module)
      7.2.5. Sensor of turn of a butterfly valve
      7.2.6. The sensor of absolute pressure in a soaking-up collector
      7.2.7. Sensor of a mass consumption of air
      7.2.8. The sensor of temperature of soaked-up air (IAT sensor)
      7.2.9. The sensor of temperature of cooling liquid (ECT sensor)
      7.2.10. Sensor of rotation of the crankshaft
      7.2.11. Sensor of rotation of a cam-shaft
      7.2.12. Contact sensor of pressure of the hydraulic booster
      7.2.13. The sensor of the content of oxygen in the fulfilled gases
      7.2.14. Detonation sensor
      7.2.15. Sensor of speed of the car
      7.2.16. Perepuskna air valve of idling (IAC valve)
      7.2.17. System of a choice of the channel absorptions (ACIS system)
      7.2.18. System of ventilation of a case
      7.2.19. Retsirkulyatsiya system
      7.2.20. Catching system паров gasoline
      7.2.21. Converter
      7.2.22. Rub in one – or how to save the catalyst
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment



7.2.12. Contact sensor of pressure of the hydraulic booster

GENERAL INFORMATION

The contact sensor of pressure is mounted on the union of the pump of the hydraulic booster.

The sensor is intended for maintenance of turns of idling of the engine during maneuver commission at a parking.

The sensor is faulty, if during maneuver commission at a parking the engine глохнет, or continues to work at the raised turns of idling.

Check

PERFORMANCE ORDER
1. Disconnect the socket and check short circuit of contacts of the sensor on the working engine. Contacts of the sensor should be opened, and in the extreme provision of wheels at turn – are closed. The faulty sensor replace.

Replacement
PERFORMANCE ORDER
1. Lift the car.
2. Disconnect the battery from weight.
3. Disconnect the socket and turn out the sensor. After installation of the new sensor remove air from the hydraulic booster (see subsection 9.2.7.).