Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
- 7. Exhaust system
   - 7.2. Systems of decrease in toxicity of exhaust gases
      7.2.2. Technical characteristics
      7.2.3. OBD II system
      7.2.4. OBD computer of II system (Powertrain Control Module)
      7.2.5. Sensor of turn of a butterfly valve
      7.2.6. The sensor of absolute pressure in a soaking-up collector
      7.2.7. Sensor of a mass consumption of air
      7.2.8. The sensor of temperature of soaked-up air (IAT sensor)
      7.2.9. The sensor of temperature of cooling liquid (ECT sensor)
      7.2.10. Sensor of rotation of the crankshaft
      7.2.11. Sensor of rotation of a cam-shaft
      7.2.12. Contact sensor of pressure of the hydraulic booster
      7.2.13. The sensor of the content of oxygen in the fulfilled gases
      7.2.14. Detonation sensor
      7.2.15. Sensor of speed of the car
      7.2.16. Perepuskna air valve of idling (IAC valve)
      7.2.17. System of a choice of the channel absorptions (ACIS system)
      7.2.18. System of ventilation of a case
      7.2.19. Retsirkulyatsiya system
      7.2.20. Catching system паров gasoline
      7.2.21. Converter
      7.2.22. Rub in one – or how to save the catalyst
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


7.2.9. The sensor of temperature of cooling liquid (ECT sensor)
GENERAL INFORMATION

The arrangement eats - the sensor on 4-cylinder engines

The arrangement eats - the sensor on 6-cylinder engines

ECT-datchik represents the thermoresistor which resistance raises at temperature fall.

Check

PERFORMANCE ORDER
1. For check disconnect from the sensor the socket and check resistance of the sensor which should be 2500–3000 Ohm at 20 ° Page.
2. Having warmed up the engine, or having removed the sensor and having placed in boiled water, check resistance of the sensor at 80 ° With which should be 250–300 Ohm.

Replacement

PERFORMANCE ORDER
1. Switch off ignition.
2. On the cold engine merge 3–4 l of liquid.
3. Turn out the sensor. At installation wrap up the new sensor a teflon tape and turn, observing extreme care.
Prevention

ECT sensor breakage because of maloperation will break normal work of all power supply system of the engine.