Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
- 7. Exhaust system
   - 7.2. Systems of decrease in toxicity of exhaust gases
      7.2.2. Technical characteristics
      7.2.3. OBD II system
      7.2.4. OBD computer of II system (Powertrain Control Module)
      7.2.5. Sensor of turn of a butterfly valve
      7.2.6. The sensor of absolute pressure in a soaking-up collector
      7.2.7. Sensor of a mass consumption of air
      7.2.8. The sensor of temperature of soaked-up air (IAT sensor)
      7.2.9. The sensor of temperature of cooling liquid (ECT sensor)
      7.2.10. Sensor of rotation of the crankshaft
      7.2.11. Sensor of rotation of a cam-shaft
      7.2.12. Contact sensor of pressure of the hydraulic booster
      7.2.13. The sensor of the content of oxygen in the fulfilled gases
      7.2.14. Detonation sensor
      7.2.15. Sensor of speed of the car
      7.2.16. Perepuskna air valve of idling (IAC valve)
      7.2.17. System of a choice of the channel absorptions (ACIS system)
      7.2.18. System of ventilation of a case
      7.2.19. Retsirkulyatsiya system
      7.2.20. Catching system паров gasoline
      7.2.21. Converter
      7.2.22. Rub in one – or how to save the catalyst
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


7.2.7. Sensor of a mass consumption of air

GENERAL INFORMATION

V6 ENGINES

Sensor mass рахода air


1. Sensor
2. Socket
3. Laying

The sensor of termoanemometricheskiya, is mounted on an air line.

Check

PERFORMANCE ORDER
1. Disconnect the socket and at the included ignition check tension existence from the battery on a conclusion 4. If tension is not present, check a chain from the main relay of injection to the sensor.
2. Attach the socket and on the working engine check tension existence between conclusions 1 and 3, having connected щупы the voltmeter to a back part of conclusions. Tension should from 1,0 to 1,5 V.Pri reduction or increase of turns of the engine tension on these conclusions should fluctuate.
3. If tension does not correspond specified, check integrity of wires of the sensor.
4. Before replacement of the sensor check it in car-care center.

Replacement

PERFORMANCE ORDER
1. Switch off ignition.
2. Disconnect the socket.
3. Remove the air filter.
4. Unscrew 2 bolts and remove the sensor.