Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
- 7. Exhaust system
   - 7.2. Systems of decrease in toxicity of exhaust gases
      7.2.2. Technical characteristics
      7.2.3. OBD II system
      7.2.4. OBD computer of II system (Powertrain Control Module)
      7.2.5. Sensor of turn of a butterfly valve
      7.2.6. The sensor of absolute pressure in a soaking-up collector
      7.2.7. Sensor of a mass consumption of air
      7.2.8. The sensor of temperature of soaked-up air (IAT sensor)
      7.2.9. The sensor of temperature of cooling liquid (ECT sensor)
      7.2.10. Sensor of rotation of the crankshaft
      7.2.11. Sensor of rotation of a cam-shaft
      7.2.12. Contact sensor of pressure of the hydraulic booster
      7.2.13. The sensor of the content of oxygen in the fulfilled gases
      7.2.14. Detonation sensor
      7.2.15. Sensor of speed of the car
      7.2.16. Perepuskna air valve of idling (IAC valve)
      7.2.17. System of a choice of the channel absorptions (ACIS system)
      7.2.18. System of ventilation of a case
      7.2.19. Retsirkulyatsiya system
      7.2.20. Catching system паров gasoline
      7.2.21. Converter
      7.2.22. Rub in one – or how to save the catalyst
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


7.2.14. Detonation sensor
GENERAL INFORMATION

The sensor of a detonation is intended for detonation registration in cylinders and reduction of a corner of an advancing of ignition. On 4-cylinder engines the sensor will screw in the block of cylinders under a head, on 6-cylinder engines 2 sensors which will screw under a soaking-up collector are provided.

Check

PERFORMANCE ORDER
1. The chain between a conclusion of the sensor and its case should not be closed накоротко. Otherwise the sensor replace.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On the cold engine merge 3–4 l of liquid.
3. On 6-cylinder engines remove soaking-up collector (see subsection 3.2.5.).
4. Disconnect the socket and remove the sensor. On 6-cylinder engines the sensor of a detonation is mounted under a soaking-up collector.
5. The new sensor tighten with the moment of 36 N of m (hermetic is put on a carving of the new sensor with the manufacturer).