Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and lock drum
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Aerial
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electroschemes


12.1.13. Screen wiper electric motor

GENERAL INFORMATION

Tension presence on the electric motor
When giving tension on a conclusion 5 (weight – a conclusion 4) the electric motor should rotate with small speed, and at a zapityvaniye of a conclusion 3 – with a high speed.

Check


Prevention

Before performance of check find an arrangement of the corresponding wires, using the scheme (see subsection 12.2.17.). Keep in mind that power wires have brighter coloring and bigger diameter rather than wires of connection with weight.


At too slowed down course of brushes check a battery condition. If the battery is charged, remove the electric motor of a screen wiper and check by hand freedom of moving of brushes. If necessary grease all sharnirny connections or repair. If this measure does not give result, check a condition of contacts, especially connections with weight. If all connections in a normal state, the electric motor replace.

If the screen wiper does not work, check a safety lock. If the safety lock is serviceable, connect the electric motor to weight a separate crossing point. If the electric motor turns on, repair connection with weight. Otherwise include a screen wiper and disconnect the electric motor socket.

Check tension presence on the electric motor (see fig. Tension presence on the electric motor). If tension is, check the electric motor, having connected it to the battery through a thin delay. If the electric motor turns on, check freedom of moving of draft. Otherwise replace the electric motor. In the absence of tension on the electric motor check tension on the switch. If tension on the switch is not present, check conducting from a safety lock to the switch. If conducting is serviceable, the switch is faulty.

If brushes work only on one speed, check conducting and a chain between electric motor conclusions. If conducting is serviceable replace the switch.

If frequency of work of brushes is not regulated, check conducting between the electric motor and the switch. If conducting is serviceable, replace a regulator.

If brushes do not come back to the parked situation at switching off, check tension on the electric motor at the included ignition and the switched-off cleaner. If tension is, the trailer switch in the electric motor is faulty. Replace the electric motor. If tension is not present, check and repair conducting between a safety lock and the electric motor.

If brushes continue to work until then ignition will not be switched off yet, disconnect the socket from the switch. If brushes stop, replace the switch. Otherwise the trailer switch in the electric motor is faulty. Replace the electric motor.

If brushes do not reach the provision of a parking, check existence of stirring subjects and draft jamming. If everything is all right, check conducting between the electric motor and the switch. If conducting is serviceable, replace the electric motor.

Replacement
PERFORMANCE ORDER
1. Remove facing of a frame of a windscreen and levers of brushes.
2. In the Camry and Solara models unscrew bolts (And) and disconnect the socket (In) a screen wiper.
3. On the Avalon models remove a bracket (And), unscrew a bolt (In) and disconnect the socket (C).
4. For removal of draft of a screen wiper on the Avalon models unscrew the specified bolts.
5. Get the electric motor with drafts.
6. Unscrew bolts and remove the electric motor.
7. Installation is carried out upside-down.