Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and lock drum
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Aerial
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electroschemes

12.1.3. Safety locks

GENERAL INFORMATION

Arrangement of the block of safety locks (Avalon)

The block of safety locks on Avalon cars is mounted under the dashboard to the left of a steering column.

Block of the relay and safety locks (Solara and Camry)

On Solara and Camry cars the uniform block of the relay and safety locks is located in a motor compartment. On Avalon cars blocks of the relay and safety locks the separate.

Relay arrangement

Some relays are mounted near a suspension bracket cap from the driver.

Chains of electric equipment of the car are protected by safety locks, breakers or fusible crossing points. The assembly block of safety locks is mounted in salon or in a motor compartment, depending on year of release and car model.

Safety locks are established on contacts of knife type and get by hand.

The fused safety lock easily is found on appearance.

It is possible to check also tension on conclusions. The safety lock fused if the voltmeter shows tension. To replace a safety lock get faulty and insert new, having pushed it into a nest.

The rated current of a new safety lock should correspond in accuracy to a current of the replaced. The rated current is specified on a safety lock. It is forbidden to use wire pieces instead of a safety lock. If the new safety lock immediately fuses, find the reason and eliminate. As a rule the peregoraniye is caused by short circuit of wires because of retyranny of isolation.