Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and lock drum
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Aerial
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electroschemes

12.1.9. Lock of ignition and lock drum

GENERAL INFORMATION

The chart for check of the lock of ignition

Provision of a key	Tested conclusions	Chain existence
LOCK	–	There is no chain
ACC	2–3	There is a chain
ON	2–3–4 6–7	There is a chain
START	1–2–4 6–7–8	There is a chain

Check

PERFORMANCE ORDER

1. Disconnect the socket of the lock of ignition, having found it on wires from the lock.

2. An ohmmeter or a control lamp check chain existence between the specified conclusions, in different provisions of a key. Replace the lock if results at least with one of checks the negative.

Replacement

PERFORMANCE ORDER

1. Disconnect the battery from weight.

2. Transfer a key to situation ASS.

3. Remove a wheel.

4. Remove both casings of a steering column.

5. Remove from a wheel shaft a combination of switches.

Replacement of the lock of ignition

PERFORMANCE ORDER

1. Disconnect from the lock of ignition of a wire.
	2. Unscrew fastening screws (are specified by shooters) and remove the lock.
3. Installation is carried out upside-down.

Replacement of the switch (drum) of the lock

PERFORMANCE ORDER

1. Press a thin screw-driver a podpruzhinenny pin.
	2. Transfer a key to situation ASS, press a pin and remove the lock switch.
3. At installation of the lock press on a pin and insert the switch into a nest on a steering column before fixing by a pin which should come into an opening on a steering column.
4. Further assembly is carried out upside-down.