Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and lock drum
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Aerial
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electroschemes

12.1.18. Headlights

GENERAL INFORMATION

Prevention

It is necessary to check adjustment of headlights each 12 months, at replacement of a headlight or after repair of a forward part of a body. Described procedure allows to adjust approximately only headlights, exact adjustment is carried out in car-care center.

Screen marking for adjustment of a beam of light of headlights

1. The line at distance from a floor to the center of headlights

2. Area of a light spot

3. The line at distance from an axis of symmetry of the car to the center of headlights
Distance of 25 ft = 7,5 m

4. Forward plane of a headlight

5. Axis of symmetry of the car

Adjustment

PERFORMANCE ORDER

	2. On the case of a halogen headlight 2 adjusting screws – screws horizontal (And) and vertical (In) adjustments of headlights are provided.
3. The simplest way of adjustment consists in bunch installation on a marking on the screen (wall).
4. Designate a tape a perekrestiya, corresponding to the centers of headlights.
5. Establish the car in 7,5 m from a wall.
6. Adjustment is carried out at normal loading of the car and a thin tank.
7. Establish a bunch of a passing beam of headlights so that the light spot settled down on 5 cm below a horizontal and on 5 cm the vertical is more right. For lifting of a bunch rotate the screw clockwise and on the contrary. The same concerns adjustment to the left-to the right. Include a driving beam of headlights and adjust a bunch so that the spot was strictly on the vertical line, directly under a horizontal. Prevention Precisely to expose bunches of a driving and passing beam in such a way it can appear impossible. In this case try to adjust more precisely a passing beam with which it is necessary to go more often and on which traffic safety more depends.
8. As soon as possible adjust headlights in car-care center.