Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1.2. Search of malfunctions
      12.1.3. Safety locks
      12.1.4. Fusible crossing points
      12.1.5. Breakers
      12.1.6. Relay
      12.1.7. Breaker of indexes of turn / alarm system
      12.1.8. A combination of switches on a steering column
      12.1.9. Lock of ignition and lock drum
      12.1.10. Dashboard switches
      12.1.11. Indexes of level of fuel and oil temperature
      12.1.12. Guard of devices
      12.1.13. Screen wiper electric motor
      12.1.14. Receiver and loudspeakers
      12.1.15. Aerial
      12.1.16. Heater of back glass
      12.1.17. Lamps of headlights
      12.1.18. Headlights
      12.1.19. Case of a halogen headlight
      12.1.20. Sound signal
      12.1.21. Replacement of lamps
      12.1.22. Lateral mirrors with the electric drive
      12.1.23. System cruise control
      12.1.24. Window regulator electric drive
      12.1.25. Electric drive of door locks
      12.1.26. Safety cushions
   + 12.2. Electroschemes


12.1.16. Heater of back glass
GENERAL INFORMATION

The heater consists from thin a provolok, baked with a glass surface.

Small destructions can be repaired a provolok independently.

Check

PERFORMANCE ORDER
1. Include ignition and a heater. If on a heater there is a tension, but heating is not present, arrive as follows.
2. Dress on щуп the voltmeter the combined strip of an aluminum foil and press down a finger to a heater thread.
3. If tension is equal in the center of a thread 6 In, the thread is serviceable, if tension is equal 12 In, the thread is torn off (break takes place between the center of a thread and weight). If tension 0 In, the thread is torn off between the center and feeding conclusion of a heater.
4. If threads are serviceable, connect (-) – a heater conclusion to weight. If indications of the voltmeter change, connection with weight the unsatisfactory.
5. It is possible to establish a place of break of a thread conducting aluminum contact on щупе the voltmeter on a thread aside from (+) – a conclusion to (-) – to a heater conclusion. The indication of the voltmeter should fall in a break place from several volts to 0.

Repair

PERFORMANCE ORDER
1. Срастить the torn-off thread of a heater it is possible by means of special epoksidny carrying-out structure (is available on sale).
2. Disconnect a heater and wait complete cooling.
3. A steel sponge carefully располируйте the damaged site also wipe alcohol.
4. Impose on the damaged site a mask from a sticky tape.
5. Prepare pitch, being guided by the instruction.
6. Put structure on a crack in a mask, smearing approximately on 18 mm in both parties.
7. 24 hours later unmask.