Toyota Camry

1996-2001 of release

Repair and car operation

Arrangement of the block of safety locks (Avalon)

The block of safety locks on Avalon cars is mounted under the dashboard to the left of a steering column.

Block of the relay and safety locks (Solara and Camry)

On Solara and Camry cars the uniform block of the relay and safety locks is located in a motor compartment. On Avalon cars blocks of the relay and safety locks the separate.

Relay arrangement

Some relays are mounted near a suspension bracket cap from the driver.

On considered cars of the relay are included in chains of such consumers as units of fuel system, a starter, fog lights, a sound signal. Relays are applied to operated inclusion and shutdown of the silnotochny consumer under the influence of an electric signal of low power. Relays are mounted in assembly blocks in a motor compartment. The relay can be got and checked, the faulty relay is replaced. Marking of the relay is put on its case or on panels of the assembly block.

Check

Designations of conclusions of the standard 4-contact relay

Non-standard 4-contact relay

On some 4-contact relays there are conclusions with numbers 1,2,3 and 5, however, their appointment just the same, as in the relay with conclusions 1-4.

Designations of conclusions of the standard 5-contact relay

PERFORMANCE ORDER

1. Check with use of the scheme of turning on of the relay gives the most reliable results. If the scheme of inclusion is absent, execute checks taking into account the following. Pair of conclusions of any relay is connected to the coil providing operation of the relay. Other conclusions become in pairs isolated or disconnected at a coil zapityvaniye. As a rule, distributing of conclusions of the relay is specified on its case. 2. Connect one of conclusions of the coil of the relay to a positive conclusion of the battery through a wire with a thin delay as a safety lock. The second conclusion connect to weight. After connection click should be listened. If click is not present, change polarity of connection (which should be observed on some relays). 3. Check chain existence between relay conclusions according to marking on the case. 4. If results of checks negative, with the relay replace.