Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl furnish
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windscreen and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11.10. Lock of a cowl and cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. Forward wing
   11.13. Trunk lid
   11.14. Latch and trunk lid lock
   11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids
   11.16. Facing panels of doors
   11.17. Door
   11.18. Latch, lock of a door and handle
   11.19. Door glass
   11.20. Window regulator
   11.21. Mirrors
   11.22. Central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. Dashboard
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. Ware tray
+ 12. Electric equipment


11.10. Lock of a cowl and cable of a drive of the lock
GENERAL INFORMATION
Prevention

Conducting and sockets of system of pneumosafety (SRS system) have yellow coloring, they are forbidden to be displaced, or to connect to them devices for check.

LOCK

PERFORMANCE ORDER
1. Outline contours of the lock of a cowl remove a plastic casing which fastens on percussion caps. Unscrew bolts of fastening of the lock (arrow) and remove the lock.
2. Hook and remove the holder of a cable of a drive of the lock and unhook a cable.
3. Installation is carried out upside-down. Adjust position of the lock so that when closing cowl bufer were slightly pressed, and the cowl was reliably locked.

CABLE

PERFORMANCE ORDER
1. Hook and remove the holder of a cable of a drive of the lock and disconnect a cable from the lock.
2. Attach to a cable a piece of a wire of sufficient length and release all brackets of fastening of a cover of a cable on a front partition.
3. Remove plastic protection of a wheel niche (see subsection 11.12.).
4. In salon remove powder facing from the driver and facing боковины.
5. Unscrew 2 screws of fastening of the lever of a drive of a cable of the lock and remove the lever.
6. Extend a cable with a sealant and a wire in salon. Disconnect old and attach a new cable, having tracked sealant existence on it.
7. Stretch a new cable in a cover for a wire.
8. Establish a cable cover in the cable lever, having tracked that the cover tip densely came into dredging of an arm of the handle of the lever.
9. Further installation is carried out upside-down. Insert a cable sealant into an opening of a partition of a motor compartment.