Toyota Camry

1996-2001 of release

Repair and car operation



Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl furnish
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windscreen and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11.10. Lock of a cowl and cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. Forward wing
   11.13. Trunk lid
   11.14. Latch and trunk lid lock
   11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids
   11.16. Facing panels of doors
   11.17. Door
   11.18. Latch, lock of a door and handle
   11.19. Door glass
   11.20. Window regulator
   11.21. Mirrors
   11.22. Central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. Dashboard
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. Ware tray
+ 12. Electric equipment



11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids

PERFORMANCE ORDER
1. Disconnect a cable and remove a trunk lid latch (see subsection 11.14.).
2. For access to a cable of a door of a mouth of a tank remove a rug of a luggage carrier and left боковину facings. Turn a cable tip counter-clockwise on 1/4 turns and get from an arm (Camry model).
3. On the Avalon models get a cable tip from an arm and deduce from gearing with the locking mechanism of a door of a mouth of a tank.
4. Remove the lower part of a back seat (see subsection 11.27.). On two-door models (coupe) it is necessary to remove a back and the lower part of a seat.
5. Hook and remove an overlay of a powder of a door of the driver. On 4-door models remove the bottom facing of the central lateral rack of a body.
6. Raise a floor rug and remove all latches of fastening of a cable to a body.
7. Unscrew two screws of fastening of the handle of a cable to a floor.
8. Raise the case and disconnect covers of cables from brackets and eyes on levers.
9. Attach to a cable a piece of a wire of sufficient length.
10. Stretch a cable from a luggage carrier to a wire exit.
11. Attach to a wire a new cable and stretch a new cable to the lever for a wire.
12. Further installation is carried out upside-down.