Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl furnish
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windscreen and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11.10. Lock of a cowl and cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. Forward wing
   11.13. Trunk lid
   11.14. Latch and trunk lid lock
   11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids
   11.16. Facing panels of doors
   11.17. Door
   11.18. Latch, lock of a door and handle
   11.19. Door glass
   11.20. Window regulator
   11.21. Mirrors
   11.22. Central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. Dashboard
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. Ware tray
+ 12. Electric equipment

11.11. Decorative panels of bumpers

FRONT BUMPER

PERFORMANCE ORDER

1. Lift the car and establish on supports.
2. Disconnect negative and then the positive plug from the battery and wait not less than 2 minutes.

3. On the Camry models unscrew a bolt of fastening of the panel of a bumper and remove plastic percussion caps of fastening of the panel of a bumper.
Prevention Buttons of the central percussion caps hook a small screw-driver, buttons not to delete, as they are pressed in steel futorka.
	4. On the Avalon models unscrew two screws and remove percussion caps of fastening of a lattice (arrow).
	5. Then disconnect sockets of antifog lamps (if are provided) and unscrew bolts (shooters) of fastening of the panel of a front bumper.
	6. Remove two bottom percussion caps.
	7. Then unscrew screws (shooters) of fastening of antisplash panels to the lower part of a bumper then access to a bolt of fastening of the panel of a bumper to the lower part of a wing (Avalon model) is provided.
8. Installation is carried out upside-down. At installation previously be convinced that latches from the back party of a bumper came into the corresponding brackets on a body. It is expedient to establish a bumper together.

REAR BUMPER

Details of fastening of a rear bumper (Avalon model)

PERFORMANCE ORDER

	1. Remove plastic percussion caps (shooters) and unscrew screws of fastening of the bottom edge of the panel of a bumper (Camry model).
	2. Unscrew nuts of fastening of a bumper on corners in a luggage carrier. For access to nuts remove facing.
	3. Open a trunk lid and remove percussion caps (shooters) or the brackets, panels of a bumper fixing the top edge. Remove the bumper panel.
Prevention Buttons of the central percussion caps hook a small screw-driver, buttons not to delete, as they are pressed in steel futorka. For removal of bolts from body openings when jamming it is possible to beat out a bolt in easy blows of a plastic hammer.
4. Installation is carried out upside-down.