Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl furnish
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windscreen and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11.10. Lock of a cowl and cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. Forward wing
   11.13. Trunk lid
   11.14. Latch and trunk lid lock
   11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids
   11.16. Facing panels of doors
   11.17. Door
   11.18. Latch, lock of a door and handle
   11.19. Door glass
   11.20. Window regulator
   11.21. Mirrors
   11.22. Central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. Dashboard
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. Ware tray
+ 12. Electric equipment


11.21. Mirrors

EXTERNAL MIRRORS

PERFORMANCE ORDER
1. On cars with the electric drive of a mirror remove facing of a door and the water filter (see subsection 11.16.).
2. Hook and remove mirror facing from the interior of a door.
3. Disconnect the electric motor socket.
4. Unscrew three bolts of fastening of a mirror. Track the route of conducting and disconnect the socket of the electric drive of a mirror at doors. Remove a mirror.
5. Installation is carried out upside-down.

INTERNAL MIRROR

PERFORMANCE ORDER
1. Insert into a groove of the basis of a leg of a mirror an edge of a screw-driver wound with an adhesive tape and вытолкните an U-shaped spring hairpin by which the leg of a mirror is kept in the basis (a screw-driver thus should come approximately on 18 mm).
2. At installation of a mirror insert a spring if it was removed. Insert a mirror into the basis and press.
3. If the plate of fastening of a mirror disappeared from a windscreen, it should be pasted special glue.