Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl furnish
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windscreen and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11.10. Lock of a cowl and cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. Forward wing
   11.13. Trunk lid
   11.14. Latch and trunk lid lock
   11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids
   11.16. Facing panels of doors
   11.17. Door
   11.18. Latch, lock of a door and handle
   11.19. Door glass
   11.20. Window regulator
   11.21. Mirrors
   11.22. Central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. Dashboard
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. Ware tray
+ 12. Electric equipment


11.17. Door
GENERAL INFORMATION
Prevention

Work is carried out together.

Removal

PERFORMANCE ORDER
1. Lower glass and disconnect the battery from weight.
2. Open and substitute under a door a support.
3. Remove the facing panel of a door.
4. Designate and disconnect all sockets, wires on weight, get all brackets of fastening of wires.
5. Remove from a door a rubber trench.
6. Unscrew a bolt of fastening of the limiter of opening of a door.
7. Designate the provision of loops on a door.
8. Supporting a door, unscrew bolts of loops and remove a door (in drawing the top loop is shown).
9. For access to bolts of a back door (arrow) open a forward door.

Installation

Installation is carried out upside-down.

Adjustment

PERFORMANCE ORDER
1. Check a condition of axes of loops. If at a door kachaniye in the vrtikalny direction люфт exceeds 1,5 mm, it is necessary to replace loops.
2. The door is regulated by moving in openings of loops of a door at the released bolts (on a body or on a door). After adjustment bolts tighten. After adjustment the door should be aflush with the next panels of a body, gaps on a contour of a door should be uniform and small. If to adjust a door it is not possible, between a loop and a body it is necessary to lay washers.
3. Check adjustment of a clamp of the lock of a door on a vertical and a horizontal. The uvula of a latch should adjoin to the clamp center. Otherwise adjust.
4. For adjustment of a clamp release screws and move a clamp in the necessary direction in easy blows of a hammer. At the correct adjustment across the door should be aflush with the central rack (or a back wing) and to be locked without big effort.