Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
- 11. Body
   11.2. Vinyl furnish
   11.3. Upholstery and rugs
   11.4. Insignificant damages of a body
   11.5. Considerable damages of a body
   11.6. Loops and locks
   11.7. Windscreen and motionless glasses
   11.8. Central lock
   11.9. Cowl
   11.10. Lock of a cowl and cable of a drive of the lock
   11.11. Decorative panels of bumpers
   11.12. Forward wing
   11.13. Trunk lid
   11.14. Latch and trunk lid lock
   11.15. Cable of a drive of unlocking of a door fuel tanks / trunk lids
   11.16. Facing panels of doors
   11.17. Door
   11.18. Latch, lock of a door and handle
   11.19. Door glass
   11.20. Window regulator
   11.21. Mirrors
   11.22. Central floor section
   11.23. Decorative panels of a forward part of facing of salon
   11.24. Casings of a steering column
   11.25. Dashboard
   11.26. Facing of a frame of a windscreen
   11.27. Seats
   11.28. Ware tray
+ 12. Electric equipment

11.13. Trunk lid



Works should be carried out together.


1. Open a trunk lid and cover the next panels of a body.
2. Remove internal facing of a cover and disconnect from a cover sockets of conducting of illumination of a luggage carrier, back lamps and extend a cable of a drive of the lock (see subsection 11.14.). Previously attach to a cable a piece of a wire of sufficient length.
3. Outline contours of loops of a cover.
4. Unscrew bolts of fastening of a cover to loops and uncover.


Installation is carried out upside-down. At installation combine loops with the contours put at removal.


1. Adjustment of provision of a trunk lid across is provided with cover moving in openings under bolts of fastening of loops after their easing.
2. The provision of a cover on height (and cover alignment with a surface of the next panels of a body) is regulated by moving of a clamp of the lock of a cover at the released bolts (arrow). Previously outline clamp contours.