| 1. Before installation it is necessary to check trailer and lateral gaps of piston rings. |
|
2. Establish the top kompressionny ring in the cylinder by means of the piston. |
|
3. Measure a trailer gap of a ring. If a gap too small, you can replace piston rings or increase a gap, having ground the ends of a piston ring a small file. |
| 4. Carry out similar procedure with all rings. |
| 5. After check and adjustment of a trailer gap, a ring it is possible to establish on pistons. |
|
6. The maslosjemny ring is established to the first. At first establish a broad ring in a flute. |
|
7. Then establish the bottom and top maslosjemny rings. |
| 8. After installation of all elements of a maslosjemny ring check, that the top and bottom rings rotated freely. |
|
|
9. Establish the second kompressionny ring by means of the special tool a mark up. Installation is made by means of the special tool – labels on rings should be directed up. |
| 10. Then establish the top kompressionny ring. |
| 11. Do similar procedures with remained pistons. |