| 1. Clean surfaces of the block of cylinders and the balancing device, establish laying. |
| 2. Establish the first piston in the top dead point. |
| 3. Combine labels (deepening) on shaft with cuts corresponding to them in a casing of shaft. |
|
4. Establish the balancing device on the block and insert bolts. Tighten bolts till the demanded moment of an inhaling in the specified sequence. |
| 5. Measure trailer gaps of shaft by means of a special measuring instrument. If gaps exceed the most admissible limits, address to the expert. |
|
6. Measure a district gap of a tooth gearing of a shaft of N1 in four various provisions (1 – a gear wheel of a cranked shaft, 2 – a gear wheel of a shaft of N1). |
|
7. By Cовместите a label And N1 shaft with a cut in a casing also measure a district gap (1 – the top half of a casing, 2 – N1 shaft). |
|
8. By Cовместите a label In N1 shaft with a cut in a casing also measure a district gap. |
| 9. If the free wheeling of a shaft exceeds admissible limits, adjust its size by means of adjusting laying. |